RAL or PANTONE® Shades in 2K Matt Polyurethane Paint Version
To see all RAL or PANTONE Colours
Download these Colour Charts below:
RAL COLOUR CHART
PANTONE® COLOUR CHART
> For the following RAL (pearl or metallic version), 2K Matt Paints are not available: RAL 9006 - RAL9007 - RAL1035 - RAL1036 - RAL2013 - RAL3032 - RAL3033 - RAL4011 - RAL4012 - RAL5025 - RAL5026 - RAL6035 - RAL6036 - RAL7048 - RAL8029 - RAL9022 - RAL9023.
The same applies for the fluorescent colours, RAL1026 - RAL2005 - RAL2007 - RAL3024 - RAL3026 - RAL6038, which can only be ordered in our fluorescent category and not in gloss version
Kit PACKAGINGS with the corresponding RAL or PANTONE® colour:
-1.450ml Kit: 1L Paint + 200ml Hardener + 250ml Thinner
-7L Kit: 5L Paint + 1L Hardener + 1L Thinner
4 Gloss Grades:
SUPER MAT 4°, MAT 20°, SEMI MAT 40°, SATIN 60°
Warning: Once the mixture 2K Matt Paint-Hardener is made, the mixture useful life is 2 hours.
We recommend to allow the mixture to stand for 5-10 minutes to stabilise the product.
MIXING ratio: by volume (not by weight) 5:1:
- 100 volumes of Tinted Paint
- 15 volumes of Hardener
- Thinning: approximately 10% (according to the painter’s preference)
Hardener and Thinner are supplied with the Paint Kits.
Before the application:
Preparation of the raw surface (plastic, metal, etc.) : Degrease, clean, dust and apply a primer if necessary.
Our adhesion primer and filler primers can be found in the PRIMERS category . They are also available in spray version
On old paints (but in good condition), no primer is necessary: a light sanding at 500-800 grit is enough to recreate adhesion.
With Spray gun (1.2 - 1.5mm)
Apply 1 to 2 thin passes
The 2K Matt Paint dries extremely fast and successive passes can be applied without waiting interval between each coat.
The matte effect can be observed during the drying process.
- Dry to the touch: 30min
- Through-drying: 4h
(solvent-based product which complies with European Standards < 420g/L)