ALUTC Top coat available in various formats:
Spray 400ml
1L
5L
25L (please contact us)
Special monocomponent clear coat for direct adhesion to on plastics and steel without primer application.
Product reserved for professionals
Colourless, glossy
Calculated VOC: 500G/L
SUPPORT:
Direct adherence on on plastics and steel and non-ferrous metals (but also wood, paper, cardboard, stone, concrete)
Spray gun nozzle diameter: 1 to 1.4 mm; air pressure: 3-4 bars
APPLICATION:
It is the user's responsibility to check that the product is suitable for its support especially when applied over surfaces with poor adhesion (chrome, galvanized plates)
Use
The surfaces must of course be prepared and clean.
With a paint sprayer, nozzle 0.8–1.4 mm
Recommended thickness: 35 µm
Compatible with all products.
Application: in 2 coats. Leave 5-10 minutes between coats.
MIXTURE: Ready-to-use
SUBSTRATE PREPARATION:
The supports must be clean and dry.
Celiron topcoat works well on chrome, polished aluminum, or galvanized
DRYING:
Drying at 20°C (60% RH) to 30 µm dry
Recoatable: 2 hours
Dust-free: 15-20 minutes
Handling: 30 minutes-1 hour
P210 reaches its maximum hardness after 7 days. Can be accelerated in an oven at 80°C for 20 minutes.
COLOURING: WITH OUR CONCENTRATED CANDY INKS BETWEEN 2 AND 6%
CLEANING THE EQUIPMENT:
Before and after use: with UNIVERSAL thinner
Between 5 °C and 30 °C: 24 months
ALUTC is not recommended on polished aluminum
Is the varnish anti-corrosion?
No, a varnish creates a coating and waterproofing effect. This protects it from water and air, which produce the corrosion effect. An anti-corrosion product blocks oxidation (already present, or to come) on the surface of the metal.
Before varnishing, it is important to thoroughly clean and deoxidize the metal (sanding) to remove all traces of corrosion, otherwise traces of rust may develop in the future, below the varnish.