Special monocomponent clear coat for direct adhesion to all metals without primer application.
Corrosion protection for all metals.
Product reserved for professionals
Calculated VOC: 761G/L
Direct adherence on metals, including silver, steel, aluminum, brass and alloys, zinc
Spray gun nozzle diameter: 1 to 1.4 mm; air pressure: 3-4 bars
It is the user's responsibility to check that the product is suitable for its support especially when applied over surfaces with poor adhesion (chrome, galvanized plates)
Application: 2 thin passes followed by a glossy coat. 1 minute interval between each coat
The supports must be clean and dry.
Over chrome, aluminum, or galvanized plates, it is advisable to prepare the surface with our DERINOXALU product
Ambient air drying at 20 °C: - Dust free: 10min.
Re-coverable with any PU clear coat after 30 minutes to 2 hours, or after 72 hours with P800 sanding
COLOURING: WITH OUR CONCENTRATED CANDY INKS BETWEEN 2 AND 6%
CLEANING THE EQUIPMENT:
Before and after use: with UNIVERSAL thinner
Between 5 °C and 30 °C: 24 months
CELIRON is not recommended on polished aluminum
Is the varnish anti-corrosion?
No, a varnish creates a coating and waterproofing effect. This protects it from water and air, which produce the corrosion effect. An anti-corrosion product blocks oxidation (already present, or to come) on the surface of the metal.
Before varnishing, it is important to thoroughly clean and deoxidize the metal (sanding) to remove all traces of corrosion, otherwise traces of rust may develop in the future, below the varnish.