ST819 60° Satin Matte Bodywork Topcoat

Overview:

Two-component satin topcoat for bodywork, furniture, woodwork, concrete, metals.
This topcoat is not only reserved for bodywork, it can be used successfully in the areas of industry and decoration.

Qualities:

The main quality of the ST-819 Satin Topcoat is its high resistance. It is also thin, very hard, easy to apply, and delivers fast drying.

Very high hardness: 3H
It is also possible to apply the product on plastics and metals.
Very high resistance to chemicals and abrasion, great stretchability and quick drying

Satin effect 60°:
A satin effect is half way between gloss and mat finish.

The ST-819 Satin Matte Topcoat creates a semi-gloss finish: the surface is glossy and reflects the light, but never shows a "wet" effect, such as seen with classic glossy bodywork clear coats.

The ST-819 Satin Matte Topcoat is usually intended for vehicle bodies (car, motorcycle, scooter, bicycle), but is also suitable for other non-automotive specific applications: furniture, microcement floor, equipment.

Direct adhesion on bodyworks, cement, plastics and metals

Variance Mat Range

The satin matte clear coat is the least matt of the 4 clear coats that are part of the Stardust® matte topcoat family. See our range of topcoats in the MATTE category:
ST-819 SATIN 60°, ST-820 SEMI-MATTE 40°, ST821 MATTE 20°, ST822 EXTREME MATTE 4°



Offer:

Complete kit including varnish (1L or 5L), hardener H423 (0.2L or 1L) and thinner (0.15L or 0.5L)
Yield: 10m² / L

Mixture

With our H423 Hardener (at 20% by weight)
and at 10% with the PU Acrylic Thinner
Leave the mixture to stand 5 min before application
Pot life: 4h

Application

Spray gun 1.0 - 1.5mm
Roller
We recommend to apply 1-2 normal passes, without charging as much as with a glossy bodywork topcoat.
(120g/m²)
The satin finish appears after the satin clear coat has evaporated and dried.

Drying at 20 °C:
- Dry to the touch: 30 min
- Through-drying: 4h
- Overcoating: 5h

Matte varnishes dry quickly.

When painting large parts, it is recommended to reduce the drying speed in order to avoid "seam" or "dusting" defects, thanks to Extra Slow Thinner 708.

Technical specifications:
Density: 0.92kg/L
VOC: 40%

Quality tests:

Adhesion Tests (according to ISO-2409/1996) : Passed
Cold-Check Test (according to UN-48205) : Passed
Moisture (according to DIN-50017) : Passed
UVs (according to ISO-11341) Passed, no colour change was noted
Pencil Hardness Test (according to UN 78267 :1996) : 3H
Chemical Resistance (according to ISO-2811) : no changes were noted according to 5 tests.

Complete car varnishing and large surfaces :

In order to slow down the drying time (a little too fast for clearcoats of this type), it is possible to request the replacement of the normal thinner
by a slow diluent. Just write us this clarification by email just after your order.