FLOOR VARNISH – SOL2K SOLVENT-FREE HYDRO POLYURETHANE

PRODUCT TYPE AND AREAS OF APPLICATION

SOL 2K HYDRO is a two-component, water-based polyurethane coating designed for renovating and decorating a wide range of surfaces.

This new-generation varnish is based on advanced water-based polyurethane resin technology.

Its specific formulation provides exceptional adhesion to most materials: wood, concrete, metal, tiles, melamine, etc.

Suitable for both indoor and outdoor use, with no yellowing or chalking over time.

It offers excellent mechanical and chemical resistance to common aggressions:

Highly resistant to shocks and impacts

Does not yellow in light

Has very strong adhesion to various substrates

FIELD OF USE

Intended for: indoor and outdoor use, for both new work and renovation.

Compatible substrates: wood, iron, concrete, tiles and similar surfaces.

COMPOSITION AND MIXING

Two-component hydro polyurethane varnish.

Proportions to be observed:

80 parts varnish (resin)

20 parts hardener

(mix precisely by weight)

Application with a roller: ready-to-use product, do not dilute.

Spray application: can be diluted with 10 to 15% water.

PHYSICAL AND CHEMICAL CHARACTERISTICS

Appearance when applied: Satin

Appearance when liquid: Transparent

Solids content (by weight): 64%

Density: - 

Pot life (useful life of the mixture): 2 hours

Theoretical coverage: 8-12m²/L per coat

VOC content: <40g/L

APPLICATION SYSTEM

Application with a special polyurethane (PU) roller is recommended for optimal results.

PREPARING THE SURFACE

Meticulous preparation of the surface is essential to ensure the adhesion and durability of the coating.

The surface must be clean, dry and free of oil, grease or any contaminants.

On tiles:

Sand mechanically (diamond sander).

Clean thoroughly, wash and remove dust.

Fill the joints with a fine filler, then sand again and remove dust.

On concrete:

For new concrete: allow a minimum drying time of 30 days.

For old substrates: sand and repair any cracks or cavities.

The application of an epoxy primer (approximately 150 mL/m² in one coat) is strongly recommended to improve adhesion.

APPLICATION

Preparation of the mixture:

Pour the resin and hardener in the proportions provided.

Mix for 2 minutes with a low-speed mixer (300 rpm maximum) to homogenise without introducing air.

Strictly adhere to the volumes indicated to ensure the product's performance.

Application:

Apply the first coat with a PU roller (coverage: 8–12 m²/L).

Leave to dry for 24 hours.

Then apply the second coat under the same conditions.

Leave to dry again for 24 hours.

Complete hardening is achieved after 8 to 10 days.

Cleaning of tools: with clean water immediately after use.

DRYING

Conditions: 20°C – relative humidity 60%

Dry film thickness: 35 µm

Dust-free: 3-4 hours

Handleable: 4-6 hours

Recoatable: 24 hours

Fully cured: 8 to 10 days

STORAGE AND PACKAGING

Available packaging: 1L kit (0.8L base + 0.2L hardener).

Shelf life: 12 months maximum in its original packaging, tightly closed and stored away from frost and heat.