Would you like to customize your Raptor with the colors and decors you have chosen ? In the same way that we manufacture and specialize other types of motorcycle paints, we would like to introduce you here to the techniques and possibilities of « special » Quad paints. When it comes to customizin...
Would you like to customize your Raptor with the colors and decors you have chosen ? In the same way that we manufacture and specialize other types of motorcycle paints, we would like to introduce you here to the techniques and possibilities of « special » Quad paints. When it comes to customizing your quad with a custom paint job, there are a series of products and methods that need to be used specifically. As experts in quad painting, we'll explain everything below.
Whether you paint a « Raptor » or any other type of quad, up to the « Rhino », it is always plastic fairings and any plastic : polyethylene and polypropylene. If you apply a quad paint without any special technique, there is a 100% chance that the paint will peel off perfectly like a plastic film after a few days.
By following our protocol to the letter, we guarantee that you will have the best chance of obtaining a totally non-peeling paint, even if you try to use a knife !
Here are the products, proposed below in this category, that you will have to get :
a blowtorch sold in supermarkets for about ten euros, with its gas refill
green abrasive sponges (400 grit)
body thinner
adhesion promoter for plastic
and of course the paint... with a spray gun or a spray can
Do each of these steps well. You will achieve the maximum level of adhesion by completing all the steps. This is important, especially if you plan to do masking and stenciling.
Step 1 : Using the blowtorch, pass the flame over the entire surface of the plastic fairing, without overdoing it, without distorting the part. You should simply observe the plastic shining, as if it were sweating.
Step 2 : Put on a pair of gloves and a mask, then soak your abrasive sponge in thinner (never use abrasive sheets), then rub the surface of the plastic. PE and PP are very tough, so you can go as hard as you want. After the operation, the plastic of the Quad will look whitened.
Step 3 : It's time to apply the plastic primer before finally painting the Quad. The primer is transparent and is applied in one or two thin coats. We follow directly with a veil of paint, to blend the two products. That's it, the adhesion is done and you just have to apply the Quad paint you want !
On a quad, you can let your imagination run wild, especially with airbrush drawings made by a specialized artist !
The fairings of a Quad are extremely flexible compared to those of a motorcycle. In the case of a Quad, it is really important to be careful, if you don't want the paint to crack after a few months.
In general, it is never the 1K paints that crack because they are thin and flexible. On the other hand, it is the 2K paints and clearcoats that are thicker and harder.
It is therefore important to incorporate 1 to 3% of softener in the final clearcoat and a little in the paint if you want to be confident.
Once the paint is applied, it is gently sanded with a P500 and the surface is ready to be painted. You can stick adhesive lines, masking with body adhesives. You can draw on it, then cut it with a cutter without fearing any detachment when removing the adhesive masks !
As for the stickers, which can easily be ordered from any print shop, they are always stuck on the sanded paint, before varnishing.
.
.
.
.
.
.
.
Please sign in first.
Sign inWe use cookies. If you continue to use this website, we will assume that you are happy with it. Find out more
